hdm wr_laser_power_std wpowers Thermal Laser standby mode does not turn off the write laser at the end of a plot. Instead, write laser output power is reduced to the value determined by this NVS parameter. If after fifteen minutes another plot is not launched, then the write laser is turned off. See the description for wpower for further details. real

0.000

0.000 to 30.000 [watts]

Applies to Thermal Head firmware version 1.30 and above cal

../nvs/hdm_cal_wpower.xmlNVS: hdm wpower

../nvs/hdm_cal_wpowern.xmlNVS: hdm wpowern

../nvs/head_cal_wpwrcal.xmlNVS: head wpwrcal

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:36:54 2008 PST